Lexmark Printer J110 Manual de usuario descargar pdf (Pagina 177)

Repair Information 4-17

4085-001

Carrier 1st Stage Drive Belt Removal

1. Remove the motor bracket from the printer frame.

2. Loosen the three screws securing the motor plate to the motor

assembly.

3. Gently depress the motor so that the 1st stage drive belt is

loosened. Retighten the three screws to fix this position.

4. Remove the original belt and install the new belt.

5. Loosen the three screws to allow the motor bracket to apply

proper belt tension. Retighten in a clockwise order, as installed

in the machine, starting with the screw closest to the tensioner

rivet. Next tighten the screw closest to the tensioner spring.

6. Ensure that the belt is aligned by rotating the compound pulley

two or three times.

Carrier Printhead Latch Removal

1. Turn the printer off.

2. Open the front cover.

3. Move the carrier to the center.

4. Remove print cartridges from the carrier.

5. Remove the clips and washer from both sides.

6. Disconnect the pogo housing link on the right side.

7. Remove the carrier printhead latch.

Multi-Purpose Feeder (MPF) Motor and Sensor

Removal

1. Remove multi-purpose feeder from the printer.

2. Remove the left and right end covers.

3. Remove one screw {A} from the right side of the rear cover.

4. Remove the rear cover.

5. Depress the clips and remove the sensor.

6. Depress the clips on the electrical connector and remove the

connector from gear bracket.

7. Remove the three screws {B} from the gear bracket.

8. Remove the gear bracket.

9. Remove the two screws.

10. Remove the motor.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 247 248

Sin comentarios

Lexmark Printer J110 Manual de usuario Pagina 177